4
© 2014 Harmar Mobility, LLC • All Rights Reserved
SECTION 1 : OWNER
AL690 Operation
LOADING & SECURING YOUR CHAIR
1. Lower the Lift Platform.
Using your remote control, lower the
lift platform until it reaches the ground and becomes level.
Do
NOT
over-lower to the point where the vehicle begins to rise
or the platform rises with the "DOWN" button pressed. This will
damage the lift or cause the lifting system to back drive.
2. Drive Chair/Scooter onto Platform.
Set your chair or
scooter’s speed control to slow speed to maneuver easily onto
the platform.
[Figure 4-1]
3. Secure the Chair.
Each corner of the AL690
platform has a restraint attached, with a hook
on the end. Place each hook in either the anchor
plate slot or in each U-bolt.
[Figure 4-2]
Pull the loose end of each restraint tight. To
release, simply press the release tab and remove the hooks.
[Figure 4-3]
4. Fold Seat Backs.
If your chair has a folding seat back, you may
want to place it in the down position for easier clearance when
loading the chair into the vehicle. Depending on the size of
your chair, you may need to remove the headrest as well.
5. Raise the Chair.
Double-check that the chair is secured
properly on the platform. While holding the hand control,
stand to the side and away from the lift. Press the "UP"
button.
[Figure 4-4]
The platform will rise and retract into the vehicle. When the
platform stops retracting, release the button. The platform
will automatically lock itself into travel position. Close the
door slowly, making sure that no part of the chair or other
objects in the cargo area contact the door.
Figure 4-1
Figure 4-4
Figure 4-2
PULL to
TIGHTEN
PUSH to
RELEASE
Figure 4-3
