2
Push bottom
of bracket
3
While holding
bottom of bracket,
rotate handle
4
Finish rotating
handle, aligning
holes
5
Install safety pin
LOCKED
NOT LOCKED
YES
NO
NO
Section 6 - Operating the Swing Away Option
Many scooter and chair owners require access to the rear of a vehicle. To accomplish this a Swing Away option is
added to the lift installation. This allows the complete lift to be conveniently and easily swung away from the back of the
vehicle and allow easy access to the trunk or lift gate. The Swing Away option can be purchased from any authorized
dealer and added at any time.
OPENING THE SWING AWAY:
Unlock the safety clamp by pulling the snap pin chained to the clamp.
Open the safety clamp by pulling the lever down and away from the lift. This will unlock the Swing Away and allow it to be
pulled open.
IMPORTANT
!!
NEVER OPERATE THE SWING AWAY WITH THE CHAIR or SCOOTER ON THE LIFT!!
This will cause damage to the Swing Away, lift and potentially cause damage to the vehicle and the chair!!
CAUTION!!
Always insure that the vehicle is on level ground before attempting to open the Swing Away.
Failure to do so may result in the operator losing control of the lift causing damage to persons and property.
Grasp the lift firmly and swing it out away from the vehicle. The Swing Away can be opened up to 180 degrees from the
closed position to allow full access to the rear of the vehicle.
CLOSING THE SWING AWAY:
CAUTION!!
Always leave the safety pin in the clamp to lock it when the Swing Away is closed.
IMPORTANT NOTE!! If your safety clamp does not SECURELY latch the Swing Away arm in the closed
position DO NOT USE THE LIFT until the clamp is adjusted by an authorized dealer. Failure to make the
proper adjustment can cause the unit to open when traveling down the road.
1
Align upper
and lower arms
UPPER ARM
LOWER ARM
ADJUSTMENT BOLT
