Harman PB 105, Инструкция по установке и эксплуатации

Страница: 27 / 48

27
4. If Starting After an Empty Hopper, Turn Feed
Adjuster to “TEST” (for one 60 second cycle). This
will feed pellets into the auger tube and also allow you
to check the motors for operation.
NOTE: The auger
motor will not operate with any of the doors open.
5. Turn Feed Adjuster to #4.
If this is your first fire or you are trying different
pellets, set the feed adjuster to #4, This is an average
number for most pellets and may need to be adjusted for
your particular fuel. After you know a feed rate setting
that works well for your application, use that setting.
NOTE: You know your feed rate is too high when:
The overheat safety feature is energized each time the
heating zone demand turns off during a high burn. OR,
If unburned or partially burned pellets are found in the
ash pan.(this may also be an indication of a burn pot in
need of scraping.)
7. Turn the MAX. TEMP. Dial on the control board to
the desired temperature. This setting must always be at
least 5° F. higher than the MIN. TEMP. setting.
Operation
6. Flip the Igniter Switch up into the “AUTO” position.
WARNING: HOT WHILE IN OPERATION.
KEEP CHILDREN, CLOTHING, AND
FURNITURE AWAY. CONTACT MAY CAUSE
SKIN BURNS.
WATER TEMPERATURE
MAX. TEMP. MIN. TEMP.