Harman Martin VDO Dotron, Руководство пользователя

Страница: 26 / 40

26 VDO Dotron User Manual
Magnetic ‘control button’
A magnetic sensor is embedded inside the VDO Dotron
behind the label on the back of the dot (see
C in Figure 1
on page 11). The sensor acts as a control button. To
activate the sensor, swipe a magnet past the side of the
dot near where the input cable tail enters the dot.
You may find it convenient to use the Martin® Test Tool
(see “Accessories” on page 35), which contains a magnet.
Activating the magnetic sensor lets you display the
product’s status, test the LEDs and reset the VDO Dotron
as explained in the following table.
Status display
To display a VDO Dotron dot’s status, swipe the magnet over the sensor once. The LEDs on the dot will give
one of the indications listed in the tables below for a few seconds.
Color Output Indication Action required
Blue Constant
Busy (e.g. booting up or writing to
flash memory). Wait a moment for normal operation
to be resumed.
Red Constant
Error. The VDO Dotron has
encountered a fatal error and can
not run.
Perform a factory reboot, followed by
a firmware upload if necessary.
Red Flashing No control source detected.
Connect a P3 system controller or
DMX controller to the network.
Green Flashing
Ready. VDO Dotron connected to P3
controller but not mapped onto the
canvas.
Set up the P3 controller to use the
VDO Dotron.
Green Constant Running normally in P3 mode. None.
Cyan Flashing
Ready. VDO Dotron in DMX mode
but not receiving valid DMX data
signal.
Send DMX data (if flashing cyan
continues although you are sending
data, check that DMX controller is
connected and configured with dot’s
DMX address).
Cyan Constant Running normally in DMX mode. None.
Table 2: Status information
Figure 13: Test Tool with magnet
www.audiovias.com