Harman Magnum Stoker, Руководство по эксплуатации

Страница: 3 / 32

3
DO NOT BURN WET COAL
wArNINgS
INTrOduCTION
This proven design by Harman features the Verti-Flow Stoker
System.
This unique system provides a very wide range of heat output.
The Verti-Flow Stoker can operate from 5000 to over 85,000 btu's
automatically.
This unit has a 100 pound coal capacity and can provide 85,000
btu's continuous for 17 hours or stretch out to over 100 hours
when less heat is required.
A thermostat is used to regulate the heat output of the stove.
When no heat is needed, the stoker stops and only runs to maintain
the fire. If heat is needed, the thermostat can turn on the stoker
at any time.
The pilot or maintenance mode is controlled by a timer box. The
"on" and "off" time can be changed to provide more or less heat
during the maintenance cycle, and to adjust for different coal quality.
This unit must be connected to a chimney capable of providing
a .04 minimum draft reading. wArNINg!! If the chimney has
no draft, coal gases may escape from the unit and stovepipe.
These gases are toxic and can be fatal. It is recommended that
a carbon monoxide detector be installed to warn of this condition.
Never sleep in the same
room with any coal
burning stove.
TESTINg INFOrmATION
This unit has been tested and approved by OMNI-TEST
Laboratories in accordance to the listed codes. This appliance
is also approved for installation into a shop.