Introducing Your New N3000 Series Devices
8
N3000 Series User Manual
ID button
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able and N-Command). Press and hold for 30 seconds to initiate a factory
restore. If you wish to factory restore all settings on the unit (including the IP address) boot the box with
the
ID
button held down.
POWER LED
On solid (green) when operating power is supplied (via PoE or local power supply). This activity is also
shown by the
PWR
LED on the rear panel.
STATUS LED
On flashing (green) when there is software activity. This activity is also shown by the
STAT
LED on the rear
panel.
Rear Panel
+12V 2A
12 Volt DC power input.
PWR LED
Same as
POWER
LED described above.
DVI LED
On (green) when a DVI connection exists (applies to the N3121/N3221).
HDMI LED
On (green) when an HDMI connection exists (applies to the N3132/N3232).
STAT LED
Same as
STATUS
LED described above.
STRM LED
On (green) when the unit is streaming video.
P0 POE
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
Provides both the network connection and the power to the Encoders and Decoders.
P1
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
OR
1G SFP port which accepts compatible fiber transceivers or direct attach cables (copper or fiber).
Modules sold separately.
Note: SFP support is model-dependent. Depending on the model, the P1 port is either an SFP (N3132/
N3232) or an RJ45 (N3121/N3221) network connection.
IR
2-pin terminal Phoenix connector. Provides IR output only (33 to 60 kHz). An emitter may be necessary
(not included).
RS232
3-pin terminal Phoenix connector which provides a serial control interface. Full duplex communication.
Available terminal speed settings: 1200 to 115200 baud rate.
AUDIO
5-pin terminal Phoenix connector which provides user-selectable balanced/unbalanced, dedicated audio
input (for Encoders) and output (for Decoders).
DVI-I IN
Video input (applies to N3121Encoders).
DVI-D OUT
Video output (N3221 Decoders). Passthru video (N3121Encoders).
HDMI IN
HDMI video input (N3132 Encoders).
HDMI OUT
HDMI video output (N3232 Decoders). Passthru HDMI video (N3132 Encoders).
VGA IN
DB-15 analog input. Allows for the use of analog video sources.
*Applies to N3132 Encoders only.
Front and Rear Panel Descriptions (Cont.)
