![background image](http://html1.mh-extra.com/html/harman-kardon/omni-adapt/omni-adapt_owners-manual_600374021.webp)
21
WPS-PIN
To connect your speaker via WPS-PIN mode:
1. Use a web browser to navigate to your Wi-Fi router or access point’s setup page.
2. Press the WPS button on the bottom of your Omni Bar+ or Omni Adapt+ for 5 seconds.
3. Enter 87654325 into the WPS-PIN section of your router or access point’s setup page.
4. The Link button on the top of the speaker will begin to quickly flash for up to one minute.
When the LED stops flashing and turns solid white, your speaker is connected.
Note:
This will connect your speaker to the network. After this is complete, you must open the
Harman Kardon Controller app and set up a new room for this speaker.
Wireless 5.1 Surround Setup
Important:
When setting up a wireless 5.1 system, you
must
connect all speakers to a 5GHz Wi-Fi network.
When setting up a surround sound system, speaker
placement is important. You should place the surround
speakers to the sides or behind the main seating area.
Angle each speaker so it directly faces the listener. Place
the speakers at the same height, preferably at about the
same height as the listener’s ears.
After placing the speakers and connecting them to
Wi-Fi (see Connecting Your Speaker to Wi-Fi on page 18),
the Controller app will guide you through assigning the
channels. In the bottom of the screen, you will see every
available speaker on the network. Drag one of the speakers to the area for the correct position, and
you will see the LED on top of that speaker flash white and hear an audio tone to identify which
speaker you’ve selected. Make sure this is the correct speaker then repeat for each channel.
You may also upgrade any existing Omni Bar+ or Omni
Adapt+ room to a wireless 5.1 system. Go to Settings >
Room management and select the room you wish to
add additional speakers in. Select Set up multichannel
and you will be guided through the same setup process
as above, with the ability to assign any other speaker
already on the network to this room.
After this step is complete, continue to Source Setup
on page 22.
Configure speakers
Available speakers
Omni 10+
Tap the speaker below to identify it,
then drag it to the correct channel
Drag and drop
speaker here
Drag and drop
speaker here
I can’t find the correct product.
Omni 10+
Ls
Rs
Room Management
Select a room to configure:
Living Room
5.1 surround
Study
Single product
SP
E
A
K
E
R
SE
T
U
P
Содержание OMNI ADAPT+
