CONTROLS AND FUNCTIONS
5
Controls and Functions
1
Power Indicator:
This LED will illuminate in
amber when the unit is in the Standby mode to
signal that the unit is ready to be turned on.
When the unit is in operation, the indicator will
turn blue.
2
System Power Control:
Press this button
to turn on the HK 970; press it again to turn the
unit off (to Standby). Note that the
Power Indi-
cator
1
next to the switch will turn blue when
the unit is on.
3
Speaker 1 / 2 Selectors:
Press to select
speaker pair 1 or 2, or both, or neither (head-
phone output only).
4
Input Source Selector:
Select desired
input source for listening by press-ing the ”Input
Source” button repeatedly (on the left will select
downwards, right upwards) until the display for
the desired source is illuminated.
5
Record Source Selector:
Select desired
source for recording to device connected to the
rear panel Tape and CDR Out sockets by pressing
the ”Record Source” button repeatedly until the
display for the desired source is illuminated.
6
Source Direct:
Press to bypass tone control
circuitry.
7
Mode Button:
Press this button to make
changes to the bass, treble and balance settings.
8
Headphone Jack:
Plug in headphones if
desired. With both ”Speaker 1” and ”2” selec-
tors in the Off position, output is supplied only
to headphones.
9
Volume Control:
Turn to raise or lower out-
put volume.
)
Main Information Display:
This display
delivers messages and status indications to help
you operate the receiver.
!
Remote Sensor Window:
The sensor
behind this window receives infrared signals
from the remote control. Aim the remote at this
area and do not block or cover it unless an
external remote sensor is installed.
2
1
3
6
7
8
9
!
)
4
5
