7
Technical Specifications
Model:
Harman Kardon Go + Play
™
II
Available in:
Black
Requirements:
iPhone/iPod with docking connector
(not included)
3.5mm (1/8") audio cable for connection
to auxiliary devices (not included)
Optional batteries for unit: 8 type D alkaline batteries
Replacement battery for
RF remote:
3V type 2032 battery
Drivers:
Two Ridge and two Atlas
™
transducers
Power:
Tweeters: 2 x 15 watts @ 1% THD
Woofers: 2 x 30 watts @ 1% THD
Frequency response:
40Hz – 20kHz
Input sensitivity:
250mV
Dimensions:
Length: 20" (500mm)
Width: 9"
(230mm)
Height: 9-1/2" (240mm)
Weight:
8.6 lb (3.9kg)
Input impedance:
>10k ohms
Signal-to-noise ratio:
>85dB
External power supply
Input voltage:
100 – 240V AC
Output voltage: 18VDC @ 3.3A
Sound Quality
Symptom
Possible Problem
Solution
Note
Cable may be bad.
Replace the cable.
Ground loop (an
unsuitable connection).
Check the input cable connection.
Input cable may be
picking up interference.
Speaker system experiences
radio-frequency interference
or picks up a radio-station
transmission.
Input cable is not
plugged in properly.
Purchase a ferrite core and
wrap the excess cable around it.
A ferrite core can be purchased
at your local electronics store.
Harman Kardon Go + Play II
unit emits a loud hum
or buzzing noise.
Turn the Harman Kardon
Go + Play II unit off and connect
it to another wall outlet.
Troubleshooting
(continued)
Symptom
Possible Problem
Solution
Note
No power to unit.
Make sure that your wall outlet or
power strip has power. Make sure
that all switches for outlet/power
strip are on and that all switches
for the unit are on.
iPhone/iPod will not charge.
The iPhone/iPod is not
making full contact with
the docking station.
Make sure that the iPhone/iPod
is seated securely into the
docking station.
Charging
The Harman Kardon
Go + Play II unit will not
charge iPhone/iPod while
in battery mode.
Technical Specifications
GO + PLAY II
HARMAN KARDON
