Harman Kardon DRIVE + PLAY [HK-DP1EU], Руководство пользователя

Страница: 6 / 12

Installing Components
Installing the Electronics Enclosure
At the selected site, install the Electronics Enclosure. Use either
the enclosed cable ties or mounting screws, as shown below.
Installing the Text Display
1. Temporarily place the Text Display at the proposed site and
check the default viewing angle while adjusting the pivot
arm. If it meets your needs, then skip to step 2. Otherwise,
change the viewing angle as follows:
a. Using the 3mm hex key, loosen the recessed hex screw
(inside the display base) until the pivot arm is free from
the display assembly. The hex screw will remain captive.
b. Select another viewing angle position (middle or top).
Reassemble the parts in reverse order and tighten the
recessed hex screw.
2. At the base, using the 1.5mm hex key, loosen (but do not
remove) the hex setscrew.
3. To install the Text Display with adhesive tape, perform the
following steps or skip to step 4:
a. Insert the mounting plate, rotate it 180°, and tighten the
hex setscrew as shown below.
6 INSTALLATION
Recessed
Hex Screw
Display
Assembly
Display
Base
3mm
Hex Key
Mounting
Plate
Adhesive
Pad
Hex Setscrew