Harman Kardon AVR 145 Скачать руководство пользователя страница 25

Страница: 25 / 151

OPERATION

Radio stations may be selected in one of four ways:

1. If you know the frequency number, enter it directly by first pressing

the Direct Button on the remote, and then using the Numeric Keys.

2. After you have programmed Preset stations (see below), either enter

the Preset number (1 through 30) using the remote or use the front-
panel Preset Stations Button to scroll through the list of presets.

3. In Auto tuning mode, with each press of the Tuning Buttons (front-

panel or remote) the AVR 145 will scan in the chosen direction until a
station with acceptable signal strength is detected. Press the Tuning
Button again to stop scanning.

4. In Manual tuning mode, with each press of the Tuning Buttons the

AVR 145 will tune the next frequency increment (0.1MHz for FM, or
10kHz for AM) in the selected direction. Press and hold the Tuning
Button for faster scanning.

Figure 57 – Tuning a Station

Press the Tuning Mode Button (TUN-M on the remote) to switch
between Auto and Manual tuning modes. When an FM station has been
tuned, pressing the Tuning Mode Button will switch between stereo and
mono tuning, which may improve reception of weaker stations.

Figure 58 – Tuning Mode

To store a station in one of the 30 presets:

1. Tune the desired station.

2. Press the Memory Button on the remote.

3. Use the Numeric Keys to enter the desired preset number.

Figure 59 – Storing a Preset Station

Recording

Two-channel analog and digital audio signals, as well as composite
and S-video signals, are normally available at the appropriate recording
outputs. Thus, to make a recording, you need only make sure to con-
nect your audio or video recorder to the appropriate output jacks, as
described in the Installation section, insert blank media and make sure
the recorder is turned on and recording while the source is playing.

NOTES:

1. Analog audio signals are not converted to digital form, and

digital audio signals are not converted to analog audio form.
However, you may record a coaxial or optical digital audio
source using either type of digital audio output.

2. Only PCM digital audio signals are available for recording.

Proprietary formats such as Dolby Digital and DTS may not
be recorded using the digital audio connections, although if
the source is connected to the AVR using the analog audio
connections, an analog recording may be made.

3. Component video sources are not available for recording.

4. Please make certain that you are aware of any copyright

restrictions on any material you record. Unauthorized duplica-
tion of copyrighted materials is prohibited by federal law.

Using

The Bridge is an optional dock that may be used with a compatible iPod
(not included). When The Bridge is connected to its proprietary input on
the AVR 145 and the iPod is docked, you may play the audio materials
on your iPod through your high-quality audio system, operate the iPod
using the AVR remote or the AVR’s front-panel controls, view navigation
messages on the AVR’s front panel or a connected video display, and
charge the iPod.

Either press the front-panel Source Selector repeatedly until the mes-
sage “DMP/The Bridge is CONNECTED” scrolls across the front panel
and semi-OSD displays, or press the DMP Button on the remote to
select The Bridge as the input source.

(Left) Figure 60 – Using The Bridge (Remote)

(Above) Figure 61 – Using The Bridge (Front Panel)

The

Bridge

AVR 145 OM (New) 8/4/06 1:19 PM Page 34

AVR145