1. FM INDOOR ANTENNA
Connect the supplied antenna (the
wire lead) to a 300
Ω
/75
Ω
adapter and
connect the adapter to the 75
Ω
T-shaped FM antenna terminal, as
shown in the Rear Panel Connection
Diagram. Change the position of the
antenna until you get the best
reception of your favorite stations.
2. FM OUTDOOR ANTENNA
An outdoor FM antenna may be used
to further improve the quality of
reception. Disconnect the indoor
antenna before replacing it with the
outdoor one. A 75
Ω
/300
Ω
adaptor
must be used only, if your antenna
system has no 75
Ω
coaxial cable.
3. AM LOOP ANTENNA
Tune in your favorite AM station and
position the loop antenna for best
reception. Try other stations and find
the position that gives the best overall
reception. When this unit is mounted
in a rack or placed on a shelf with
sufficient space behind, hang the
antenna on a wall in the direction
which gives the best reception.
NOTE: If noise is heard during AM
reception, move the antenna for
better reception. To prevent
undesired noise, the AM LOOP
ANTENNA should be located away
from the remote control cord over 12
inches (30 cm).
4. TV / AUX INPUT JACKS
This input is provided for any source
you want to hear. An additional
compact disc player, tape recorder,
TV video cassette recorder (VCR), etc.
can be plugged into these jacks (only
for playback).
5. CD INPUT JACKS
Connect the output cables of a
compact disc player to these jacks.
6. TAPE PLAY JACKS
Connect the line output of your
CASSETTE DECK to these jacks.
7. TAPE REC JACKS
Connect the line input of your
CASSETTE DECK to these jacks.
8. VIDEO / AUDIO INPUT
(PLAY) JACKS OF VCR1
Connect these jacks to the corre-
sponding OUTPUT jacks of your VCR.
9. VIDEO / AUDIO OUTPUT
(REC) JACKS OF VCR1
Connect these jacks to the
corresponding INPUT jacks of a VCR.
VIDEO VCR1 OUT jack: Connect this
jack to the VIDEO INPUT jack of the
VCR.
VCR1 REC jack: Connect these jacks
to the AUDIO INPUT jacks of the
VCR.
10. VIDEO MONITOR JACK
Connect this jack to the VIDEO
INPUT jack of a TV/MONITOR.
11. REMOTE CONTROL
OUT JACK
Connect this jack to the REMOTE IN
jack on a Harman Kardon
component. Use one of the
accessory mini-plug cables.
You can control many other Harman
Kardon components in your system
using the AVR 10 remote commander.
12. MULTI-ROOM
REMOTE IN JACK
Connect a Harman Kardon HE 1000
remote IR sensor to this jack. You can
operate the unit by remote
commander through the adaptor. It is
convenient when the unit is located in
a separate room.
13. FRONT PRE OUT
AND MAIN IN JACKS
Pre Out
When a separate power amplifier is
used to drive the front speakers,
connect the power amplifier input to
these jacks (see page 8).
6
Rear Panel Connections
ENGLISH
AM LOOP ANTENNA SETTING
Stand and place it on a shelf
or hang it on a wall.
LEG
AVR10 engelsk 11/01/98 10:10 Side 6