12
Operation
ENGLISH
BASIC OPERATION
1. Press the POWER button to ON.
The display panel will light up.
Note: If you prefer to turn the unit
off and on with the remote control,
this button must be left in the ON
position. The remotes Standby
button will then turn the unit ”ON”
and ”OFF” by taking it in and out of
standby mode.
2. Select the desired program source
with the INPUT FUNCTION
SELECTOR buttons. The selected
input function will appear in the
display.
3. Operate the selected component
for playback.
• When a video source is selected,
the picture will appear on the
television and sound will be
heard from the speakers.
• When playing back a video
source with surround sound
effects, refer to the “Surround
Sound Effects” of this manual.
• When the TAPE MONITOR button
is set to ON so that the TAPE
MONITOR indicator lights up,
selected program sources other
than TAPE cannot be heard from
the speakers.
To listen to a program source
other than cassette deck be sure
to set the TAPE MONITOR button
to OFF.
4. Adjust the volume to a comfortable
listening level with the VOLUME
control or MASTER VOLUME
UP/DOWN buttons on the remote
control.
5. For private listening, insert a 6,3
mm plug of the headphone into the
HEADPHONE jack.
• When the headphones are
plugged in, sound from the
speakers is cut off.
LISTENING TO BROADCASTS
Press the AM or FM button and use
auto, manual or preset tuning to
select a radio station.
AUTO TUNING
If broadcast signals are strong
enough, auto tuning is possible.
1. Press the FM or AM button to
select the desired band.
2. Press the Seek Stereo button so
that AUTO lights up in the display.
3. Press the UP or DOWN
TUNE/PRESET button. Tuning will
start automatically and stop at a
broadcast station frequency with
sufficient signal strength.
MANUAL TUNING
Auto tuning may not be possible if the
broadcast signal is weak. If so, use
manual tuning.
1. Press the FM or AM button to
select the desired band.
2. Press SEEK STEREO to delete the
AUTO in the display.
3. Press the UP or DOWN
TUNE/PRESET button until the
desired station frequency is
reached.
• Each time the button is pressed,
the frequency changes by a step.
• When the button is kept pressed,
the frequency changes
continuously in sequence.
PRESET TUNING
The receiver has a memory for up to
30 preset stations.
If the station frequencies are stored in
this memory, they can be tuned in by
a simplified procedure:
MANUAL PRESETTING
Up to 30 stations can be preset at
random, regardless of the reception
band.
1. Tune in the station to be stored in
memory using the auto or manual
tuning.
2. Press the MEMORY button. The
MEMORY indicator will light up for
5 seconds.
3. Select the preset number with the
UP or DOWN TUNE/PRESET
button or the numeric buttons on
the remote while the MEMORY
indicator is lit.
4. Press the MEMORY button to store
the station.
• When using the NUMERIC
buttons on the remote, the
station is stored in memory
without pressing the MEMORY
button again.
• When selecting single digit preset
numbers with the NUMERIC
buttons on the remote, press the
corresponding number without
pressing ”0” first.
5. Repeat steps 1 to 4 to preset other
stations.
AVR10 engelsk 11/01/98 10:10 Side 12