Harkwood Services cmdBridge, Справочное руководство

Страница: 5 / 24

5 of 24
CON USB
STATUS
LAN OUTPUT
INTPUT
RX TX
② ④ ⑤
③
①
Installation
Front Panel connections and indicators
①
Console port
- used to configure cmdBridge.
NOTE Console port can also be used to supply power, no external PSU is required during
configuration or deployment if the USB power source can supply 1A.
NOTE Console port is a Serial over USB port, running at 230400 baud, 8 bits, no parity.
NOTE Do not use a USB cable of 2m or longer.
TIP Recommend serial console software for Windows is ‘PuTTY’ and for Apple Mac computers
‘Serial’ by Decisive Tactics.
②
USB Port
- USB memory stick connection to enable configurations to be uploaded / downloaded,
captured data to be stored, and for firmware upgrades.
③
Status LED
- Indicates the system mode or fault condition as below;
Green Pass-through mode
Blue Translation mode
Red System fault, please see troubleshooting section for details
④
LAN LED
- Indicates the LAN status, the LED is lit when one or more port is connected. The LED
colour indicates the MAC address being used as below;
Green System default
Blue Custom
NOTE A solid colour indicates a IP address is set, either statically assigned or provided by DHCP.
A blinking colour indicates DHCP is in progress.
⑤
Data in/out
- Indicates that data is being received (RX) or transmitted (TX) on the respective
port, the LED colour indicates the physical interface type as below;
Green RS232 data
Blue IP data
Red TX only, the remote end is not accepting the IP connection, no data could be sent.