Harken Performa Winch 50.2 PTP, Руководство по установке и обслуживанию

Страница: 6 / 16

6 Performa
™
Winch
50.2 PTP
Installation and Maintenance Manual - Mod.C
Installation procedure
Carry out the
Procedure
, then install the winch on the deck in the chosen position.
A.
Position the base of the winch on the deck and mark the position of the holes or use the drilling
cut-out template at the point where you have decided to place the winch.
Below is a reduced scale diagram.
The drilling cut out template is available on the Harken
®
website, www.harken.com
B.
Remove the winch and drill the five 8.2 mm diameter holes.
C. Bolt the base of the winch to the deck using five M6 bolts (not supplied by Harken
®
), correctly
chosen for the thickness and type of the boat deck. Consult the yard that built the boat in case of
doubt.
WARNING!
To install the winch on the deck, use only bolts in A4 stainless steel (DIN 267 part11).
Bolts made of other materials may not have sufficient strength or may corrode which can
result in winch pulling off deck suddenly and unexpectedly during high loads causing
severe injury or death.
NOTICE
To mount winches on the deck, do not use countersunk bolts.
D. Fill the mounting holes with a suitable marine sealant.
E. Remove the excess adhesive/sealant from the holes and base drainage channels
final pinion
position
Ø150
46°
46°
64°
70°
70°
64°
Winch outside Ø194
Ø8.2 n°5