Harken HYDRO POWER UNIT 1, Инструкция по установке и эксплуатации

Страница: 15 / 28

Hydro 1 15
Commissioning
Manufacturer Brand Name Manufacturer Brand Name
Amoco
® Rykon 46
Gulf
® 46AW
Ashland Valvoline
® Evergol 46
Mobil
® DTE 20 Series 25
Atlantic Richfield
® Duro AW-S-215
Mobil
® DTE 10 Series 19
BP
® Energol HLP
Pennzoil
® Magnus A 315
Chevron
®
USA
AW Hydraulic Oil 46
Phillips Petroleum
®
Corp.
Tellus 46
Citgo
®
Petroleum Corp.
A/W Pacemaker XD-46
Shell
® Tellus T46
Citgo
®
Petroleum Corp.
A/W 46
Shell
® SUNTAC WR 150 WR
Conoco
®
(Continental)
Super Hydraulic Oil 21
Texaco
® Rando HD 46
Esso
® Nuto H46
Union
® Hydraulic Oil Unax AW 215
Exxon
® Nuto H46
Registered trademarks: Amoco
®
- Amoco Oil Company: Ashland Valvoline
®
- Ashland, Inc.; Atlantic Richfield
®
- Atlantic Richfield Co.; BP
®
- BP p.l.c; Chevron
®
USA - Chevron Intellectual
Property LLC; Citgo
®
Petroleum Corp. - Citgo Petroleum Corp.; Conoco
®
(Continental) - ConocoPhillips; Esso
®
and Exxon
®
- ExxonMobil; Gulf
®
- GULF Oil International; Mobil
®
- ExxonMobil;
Pennzoil
®
- SOPUS Products; Phillips Petroleum
®
Corp. - Phillips 66; Shell
®
- SOPUS Products; Texaco
®
- Chevron Intellectual Property LLC: Union
®
- Phillips 66.
Filling Reservoir
Pump hydraulic oil through an adequate filter into reservoir. Fill until oil
level indicator is
2 /
3
- 3 /
4
full. Inspect for leaks. Reservoir capacity is
30 liters (7.9 gal.). Approximately 25 liters (6.6 gal) will be needed for
the reservoir. If installation is completed with empty hoses, extra oil
will be needed to meet the
2 /
3
- 3 /
4
tank fill indicator requirement.
Hydraulic Oil
Harken recommends mineral-based, ISO 46 grade oil. Refer to Oil
Equivalent Table below. If HPU is primarily used in an extreme cold
weather environment, ISO 32 is suitable.
Characteristics of good quality, mineral-based hydraulic oil are:
• Good anti-wear performance
• Resistance to oxidation depredation
• Protection against rust and corrosion
• Resistance to foaming
• Ability to separate water rapidly
• Suitable for widely varying temperature conditions
• Good low temperature flow properties
• Retains viscosity/temperature characteristics while in service
• Universally available
Note: If the hydraulic installation was completed with empty hoses,
be sure to have extra oil on hand to top off the tank as the hoses
are filled.
Filler Tube
Oil Level
Indicator
CAUTION! Never run the HPU pump without oil. This will void warranty.
When commissioning hydraulic equipment, it is extremely important to carefully follow each procedure to avoid premature system damage
and/or failure. Secure connections, ensure cleanliness, confirm proper fluid levels and perform all recommended tests. The following are
instructions to ensure proper commissioning of your Hydro 1.
Oil Equivalent Table