8
Slip top track slugs into mast groove. Use
32 mm (
3
/
4
") mounting slug for top stop.
Mast-up:
Tape top stop slug even with top
of upper track. Tape other slugs in place.
One drop blue Loctite
®
adhesive into each
splice slug hole.
Thread 5 mm x 25 mm endstop screw
through endstop, track, and into slug.
Mast-up:
Remove tape. Tighten screw
to hold track.
Slide slugs into place with putty knife.
Loosely install 5 mm x 20 mm screws.
Tip: Use putty knife to see if screws
are loose enough to slide in groove.
Remember: Tracks may stick when
reaching a spliced area on mast.
Assembly—Slug-Mount
Install Track
Note:
When using HC8811 track,
put slugs at 50 mm intervals at sail
headboard location at full hoist and
when sail is reefed. Otherwise skip holes
so slugs are at 100 mm hole spacing.
Full hoist
High-load track with
50 mm hole spacing.
100 mm
omit every other
screw and slug.
High-load track with
50 mm hole spacing.
50 mm
reef position.
100 mm
omit every other
screw and slug.
Loctite is a registered trademark of Henkel AG & Company KGaA.
