1
Remove Disconnect Rot and Handle Socket
Loosen disconnect rod using flethead screw driver as shown
below
Remove Disconnect Rod and handle cocket.
Disassemble Winch Before Installation
2
Remove Stripper Arm and name Ring
Loosen the three (3) allen screws
Remove stripper arm
Remove Name Ring and black cover ring.
3
Remove Drum Assembly
Loosen the four (4) allen screws inside the stripper arm support
Remove stripper arm support
Carefully lift off drum assembly, main bearings may remain inside
drum due to oil and grease
4
Remove Housing
Loosen the six (6) allen screws holding the housing to the
alluminium base
Lift off housing.
5
Remove Mounting Plate from Motor/Gearbox Ass’y
Loosen the four (4) allen screws
Lift off mounting plate:
6
Drive Position
Place winch base on mounting plate, making sure fastener holes re
corresponding
Mark drive position.
