17
F. OPERATION: LIGHTING
LP GAS LIGHTING PROCEDURE:
1. Check all connections for leaks using the leak test as
explained on page 15.
2. Open the smoker door.
3. Be sure the burner control knobs is in the “OFF”position.
4. Open the LP cylinder valve 1-1/2 turns by turning counter-
clockwise.
5. To light the unit with the push-button ignition,push in and
turn one burner control knob counter-clockwise to the
HIGH/LIGHT setting. Then repeat for the other burner.
Please Note: You must keep the control knobs pushed in to
allow the burner to initially light.
6. Immediately push the igniter button to click it several times
(you should see a small spark jumping from the end of the
electrode rod to the side of the burner). If a burner does
not light within 3 to 5 seconds, turn the burner control knob
OFF and wait 5 minutes before repeating the steps again. If
burner still fails to light, try match lighting the smoker using
the instructions below.
7. Once both burners are lit, close the door to allow heat
to accumulate. The dampers can then be adjusted to the
desired setting to allow proper air flow and combustion.
Damper adjustment tips are listed on the next page.
To match light the burners, repeat steps 1 through 5 of the
igniter lighting system above and continue with the following
procedure:
Remove the wood chip box and its rack from inside the smoker.
Quickly turn one control knob to the light position.
Strike a paper match and drop it into the burn chamber, next to
the burner. Repeat for the other burner.
If the burner does not light within 4 or 5 seconds, turn the
control knob OFF, wait for 5 minutes, and repeat the process.
If the burner flame is accidentally extinguished, turn the control
knob OFF, wait for 5 minutes before opening the door, and
repeat the lighting procedure.
WARNING
NEVER ATTEMPT TO LIGHT THE SMOKER WITH THE
DOORS CLOSED
OPEN BOTH DOORS TO LIGHT SMOKER
CAUTION
The water bowl and wood chip box must be inserted over the burner during operation. This is to protect
the burner from falling particles, grease drippings and accidental spill over from the water bowl.
Содержание HK0535
Страница 1: ...Owner s Manual ASSEMBLY CARE SAFETY INSTRUCTIONS Item No HK0535 BIG BOSS GAS SMOKER v6 7 16 ...
Страница 2: ......
Страница 6: ...6 A HARDWARE PACK ...