23
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
PREVENTION/ CURE
Burner will not light
No Gas Flow
Check LG Gas cylinder is full. Replace gas cylinder.
Obstruction of gas flow
Check for bent or kinked regulator hose.
Clean burner ports.
Burner is off the valve
Re-engage burner onto the valve.
Spider webs or
obstruction in venturi
Clean venturi.
Burner ports blocked
Clean burner ports.
Bad piezo ignitor spark
Check to see if burner will match light.
Check to see if piezo electrode is producing spark.
The spark should be visible and jumping from the
ignitor to the burner. If you cannot see any spark
you may need to slightly adjust the position by
bending the electrode a little closer or further away
from the burner.
Replace piezo ignitor or replace the piezo wire.
Irregular flame pattern.
Flame does not run the
full diameter of burner
Burner ports blocked
Clean burner ports.
Flame is yellow or orange Burner may be blocked
Clean burner ports.
Spider webs or
obstruction in venturi
Clean venturi.
Food residue or grease
on burner
Clean burner .
Burner is off the valve
Re-engage burner onto the valve.
Burner may have
residue
Turn burner to high setting for 5 mins and burn
with the door open.
Burner will not stay
alight
Gas Bottle is empty
Check LG Gas cylinder is full. Replace gas cylinder.
Flame Failure Device
(FFD) sensor is not
positioned correctly
Reposition FFD sensor. Refer to page 10 of manual
for instructions.
FFD device is faulty. Replace FFD.
Flare up
Grease build-up
Make sure the water pan and the wood chip box are
inserted in correct position.This is to protect the
burner from falling particles, grease drippings and
accidental spill overs from the water bowl.
IF YOU HAVE ANY QUESTIONS OR QUERIES ABOUT THE OPERATION OR MAINTENANCE OF YOUR GAS
SMOKER PLEASE CALL THE CUSTOMER SERVICE NUMBER ON 1300 799 787 OR
(03) 9702 8823
OR
EMAIL [email protected]
