INSTALLATION
Highland Glow - 22” & 26” Models - Log Placement
Step 1
– Identify each of the 6 logs in the set by comparing them to the log pictures below. (Fig 1 &2)
Step 2
– Identify the Back Log Plate in the log box. (Fig 1)
Step 3
– Install the Log Plate on the Back Burner Plate by placing the tabs on the bottom of the Log Plate in the holes on the
Back Burner Plate. Assure that the tabs on the Log Plate are facing forward toward the grate on the front of the set.
Step 4
– Place the Back log (1) on the Log plate with the char area facing forward.
Step 5
- Install the Front Logs (2 & 3) by placing the locator pins on the bottom of each log in the holes on the Front Burner Plate.
(Fig 1)
Step 4
– Install the left Top Log (4) by placing the flat side of the log on the notches on the top of the back and front log. The
branch should be facing forward. (Fig 1 & 2)
Step 5
– Install the right Top Log (5) by placing the flat side of the log on the notches on the top side of the back and front log.
The branch should be facing forward. (Fig 1 & 2)
Step 6
– Install the middle Top Log (6) with the charred end resting in the notch on the top of the Front Left Log and the other
end resting on the front flat area of the right Top Log.
1
2
3
4
5
Back Log
Front Log
Top Log
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Step 4 –
Assure that all of the logs have at least a 1” clearance around the burner ports of the Back Burner (Fig 3).
Step 5 –
Once the set is completely set up, observe the operation of the set.
The back flame should not be coming in
contact with any logs.
The front flame should cause a glowing effect on the ember material and part of the surface of the
front logs (Fig 4).
1”
1”
1”
1”
TOP VIEW
Keep a minimum 1” Clearance around burner ports on the Back Burner.
Burner Ports on
Back
Burner
1
Front Log
6
