Hardt INFERNO 3500, Руководство по установке

Страница: 13 / 19

Page 13 of 19
CUS
-009
-0008
-0
3
5.3.4 Finishing up
1. Lift the bottom rotisserie off of its pallet and set it
on the floor. Use the appropriate instructions for
your lifting jig/bracket in sections 5.3.2 and 5.3.3.
2. Remove the lifting jig/bracket from the bottom
rotisserie (with wheels) and move it to the top
rotisserie (without wheels). Be careful not to
damage the door or other components. (See
Figure 5-4 ).
3. Ensure the screws holding the rectangular-
spacers on the roof of the bottom rotisserie are
tight (see detail 1 of
Figure 5-3 ).
4. Use the wood lifting jig or metal lifting bracket to
lift the top rotisserie from its pallet (refer to the
appropriate section for details)
5. Place the top rotisserie on to the bottom one. The
four tabs on the spacer must be inserted inside
the frame of the top rotisserie. The holes in the
base of the top rotisserie must align with the holes
in the tabs on the spacer of the bottom rotisserie.
6. Insert bolts and tighten (As shown in Figure 5-6 ).
7. Remove the wood lifting jig or metal lifting bracket
from the top rotisserie. Be careful not to damage
the doors or other components of the rotisseries.
8. Inspect rotisseries for any remaining plastic left
over from the manufacturing and packing
process, remove if found.
9. Place the rotisseries in their operational area.
10. Verify the rotisseries are levelled from front to
back and side to side. Raise or lower the caster
wheels if necessary (See
Figure 5-7 ).
Figure 5-6: Secure at all 4 corners
Figure 5-7: Adjust caster wheels to level rotisseries.