Hardi ZENIT A750, Инструкция

Страница: 38 / 55

To put water in the main tank, take off the lid on top of the tank. We recommend you use as clean water as possible
for spraying.
Always fill the tank with the upper filter in position to stop unwanted particles from going into the tank.
Do not put the water hose right into the tank. Keep it outside and
simply aim inside. If the hose were to get inside the tank and the
pressure from the water supply were to be reduced, the chemi-
cal products could siphon from the tank to the water source and
contaminate the water there.
To empty the tank via the drainage valve, turn the pin on the lower
right-hand side of the auxiliary tank. To close it again, turn the pin
again and the valve will close automatically.
Do not forget to use protective clothing and gloves when
doing this.
Tank
Pressure filters
Pressure filters stop allowing those impurities which have not
been filtered out during suction from getting to the nozzles. To
avoid blockage of those filters it is very important to check them
from time to time and empty them at the end of every treatment
so that the chemical product does not solidify and block them
up.
To completely empty the filter or clean it, take off the
h o u s i n g
using gloves.
A
A
Agitation
The dual-nozzle agitation system injects the chemical product at
high pressure from the pump inside the tank creating a turbulence
that mixes the product with the water for a uniform application.
The fitted agitator is the standard one, with two 2mm ventury no-
z z l e s
. The ventury nozzle allows the flow to come out of the
main tank at high pressure.
B
B
5.2
5 - Operating