Hardi RANGER PRO, Инструкция

Страница: 21 / 76

4.1
Although the sprayer has been applied with a strong and protective surface treatment on steel parts, bolts etc. in the fac-
tory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILLO or SHELL ENSIS FLUID) on all metal
parts in order to avoid chemicals and fertilisers discoloring the enamel. If this is done before the sprayer is put into opera-
tion for the first time, it will always be easy to clean the sprayer and keep the enamel clean for many years. This treatment
should be carried out every time the protection film is washed off
For the unloading of the sprayer, you need a crane. When unloading
with a crane please observe the lifting points as shown on the pictu-
re, and make sure that the straps or belts used for lifting are strong
enough.
The support leg is stored in retracted position and secured by the
lock pin when the sprayer is attached to the tractor.
To retract the support leg: Lift the leg, then pull the lock pin out and
tilt up the support leg. Place the lock pin into the upper locking
hole..
Support leg
Before putting the sprayer into operation
Unloading the sprayer from the truck
General info
4 - Sprayer setup