Hardi MASTER VHY Series, Инструкция

Страница: 21 / 48

21
GB 08 00 MA
Operation - liquid system
T021-0012
A
B
C
T041-0002
F FF
F
Filling of illing of
illing of illing of
illing of w w
w w
wa aa
a
ater ter
ter ter
ter
F FF F Filling of illing of illing of illing of illing of main tank main tank main tank main tank main tank
Water can be filled into the main tank as follows:
1. Filling through tank lid.
2. Suction filling device (optional equipment)
3. Fast filling device (optional equipment).
Tank should normally be filled 1/3 with water before
adding chemicals. Always follow instructions given on
the chemical container!
IMPORTANT! If the sprayer is put aside with liquid in the
main tank all MANIFOLD valves must be closed.
1. Filling through tank lid
Water is filled into the tank by removing the tank lid
located at right hand side of sprayer tank. It is recom-
mended to use as clean water as possible for spraying
purposes.
Always fill water through the strainer basket to prevent
foreign particles from entering the tank.
An overhead tank can be used in order to obtain high
filling capacity.
WARNING! Do not let the filling hose enter the
tank. Keep it outside the tank, pointing towards
the filling hole. If the hose is lead into the tank
and the water pressure drops at the water supply plant,
chemicals may be syphoned back and contaminate the
water supply lines, plant and well.
2. Suction filling device (optional equipment)
WARNING! Avoid contamination or personal
injury. Do not open suction valve towards
Suction Filling Device unless pump is running
and filling hose is connected. If this valve is opened
without pump running, liquid will stream out of the
MANIFOLD.
The Suction Filling Device is operated as follows:
1. Remove cover and connect suction hose to Suction
Manifold.
2. Engage diaphragm pump and set P.T.O. revolutions at
540 r/min.
3. Turn handle on Suction Manifold towards Filling
Device.
4. The tank is now filled with water. Keep an eye on the
liquid level indicator.
5. Turn handle on Suction Manifold away from Filling
Device to discontinue filling process. Then disengage
pump.
6. Disconnect suction tube and replace cover.
NOTE! Observe local legislation regarding use of Filling
Device. In some areas it is prohibited to fill from open
water reservoirs (lakes, rivers etc.). It is recommended
only to fill from closed reservoirs (mobile water tanks
etc.) to avoid contamination.
WARNING! If suction hose/filter is carried on the
sprayer during spraying, it can be contaminated
by spray drift which will be transferred to lake/
river when filling!
3. Fast Filling Device (optional equipment)
The Fast Filling Device is operated as follows:
1. Ensure spray liquid tank contains at least 50 litres of
water.
2. Remove cover ( A ) and connect suction hose ( B ).
3. Turn handle on Pressure Manifold towards Fast Filler.
With the P.T.O. at 540 r/min the pressure gauge
should indicate about 10 bar.
4. If water is not seen in the transfer tube, prime by
turning valve ( C ).
5. Keep an eye on the liquid level indicator.
6. Turn handle on Pressure Manifold away from Fast
Filler to discontinue filling process.