Hardi FORCE, Руководство оператора

Страница: 30 / 52

28 HARDI ® FORCE™ BOOM OPERATOR’S MANUAL
Adjusting Rear Transport Hooks
The rear transport hooks (Fig. 26) should be adjusted so there is not
only clearance for the tires (Fig. 27), but also clearance for the tractor
cab (Fig. 28) at a full turn.
Note: Transport hook positions are not set at the factory for
tractor or tire clearance. This adjustment needs to be made
after connecting the sprayer to the tractor for the fi rst time.
WARNING: WHEN MAKING ADJUSTMENTS TO TRANSPORT
HOOKS, MAKE SURE THERE ARE SAFETY
SUPPORTS (JACK STANDS) UNDER THE BOOM, IN
CASE THE BOOM SHOULD FALL.
1. Raise the boom all the way up.
2. Fold the boom in and lower until it fi rst
touches the Transport Brackets.
3. Measure the distance from the rear of
the boom to the ground and then lower
the boom to fully rest into the Transport
Brackets.
4. Re-measure the distance from the rear of the boom to the ground.
If the difference between the two measurements is greater than 2",
then the transport hooks need to be re-adjusted.
5. Shorten the overall hook length (Fig. 26) by moving both sides in
one hole.
6. Repeat steps 1-5 until the difference is less than 2".
Note: It may be necessary to raise the front transport brackets
and repeat steps 1-5 if there is not enough tire clearance
(Fig. 27) or tractor cab clearance (Fig. 28).
Fig. 27
Fig. 28
Fig. 26