A
A
LPHA 2500
G A R A G I N G
CHAPITER
6- 1
677824
01/02
This chapter deals with the actions to be taken for the purpose of garaging the sprayer
in the winter period. They must be followed scrupulously as the guarantee does not
cover damage caused by freezing
6 - G A R A G I N G
- Protect the electrical components (alternator,branch box, connectors, regulating valve) from
splashes of water.
- Clean the sprayer completely - inside and outside. Make sure that all valves, hoses and auxiliary
equipment have been cleaned with detergent and flushed with clean water afterwards, so no che-
mical residue is left in the sprayer
- Renew possible damaged seals and repair possible leaks.
- Empty the sprayer completely and let the pump work for a few minutes. Operate all valvess and
handles to drain as much water off the spraying circuit as possible. Let the pump run until air is
coming out of all nozzles. Remember to drain the rinsing tank also.
- Pour 80 to100 litres of water with antifreeze into the main tank. See the antifreeze instructions to
obtain sufficient protection from freezing.
- Spray for a few moments at the nozzles to protect the nozzles.
- Engage the pump and operate all valves and functions on the Manifold, operating , filler etc.
allowing the anti-freeze mixture to be distribued around the entire circuit. Open the operating unit
main on/off valve and distribution valves so the anti-freeze is sprayed through the nozzles as well.
The anti-freeze will also prevent O-rings, seals, diaphragms etc. from drying out.
- Lubricate all lubricating points according to the lubricating scheme - regardless of intervals stated.
- Lightly lubricate the spherical part of the valve. Excessive lubrication may lead to clogging of the
spray nozzles. See chapter 6.
- Protect the valve from freezing.
- When the sprayer is dry, remove rust from possible scratches or damages in the paint and touch
up the paint.
- Remove the glycerine-filled pressure gauges and store them frost free in vertical position.
- Apply a thin layer of anti-corrosion oil on all metal parts. Avoid oil on rubber parts, hoses and
tyres.
- All electric plugs and sockets are to be stored in a dry place. Remove the Hardi Nova control
box and display from the cab and store them dry and clean (in-house).
- Apply grease on all hydraulic ram piston rods which are not fully retracted in the barrel to pro-
tect against corrosion.
- Chock up the wheels, to prevent moisture damage and deformation of the tyres.
- Fill up completely the fuel tank to prevent condensed water into the tank.
- Clean the engine air filter
- Cut the battery cut-off and disconnect the battery.
- Fill completely the diesel oil tank to prevent the condensed water in the tank.
- Place the mobile unit under cover
6 - 1 O F F - S E A S O N S TO R AG E
