Hardi Eagle Boom, Руководство оператора

Страница: 10 / 32

10
EAGLE BOOM
2 With the fold cylinder pressurised, determine if the
intermediate section needs to be adjusted to the front
or rear to come into alignment with the centre frame.
NOTE! Because of adjustments made later, it is
better to start with the wing assemblies angled
slightly to the rear.
3 Relieve pressure from cylinder by folding boom in a
few inches.
NOTE! Cylinder rods have a machined flat, which if
visible, can be used for adjustments. If using the
machined flat for adjustment, leave the rod eye
pinned to the boom and loosen the lock nut. Refer
to Fig 19.
4 Disconnect the cylinder rod eye (B Fig 10) from the
intermediate boom section.
5 Loosen the lock nut (A Fig 10) and adjust the rod eye
(B Fig 10) in to move boom forward or out to move
boom rearward. Tighten the lock nut (A Fig 10).
6 Attach the cylinder rod to the boom and pressurise
the cylinder to check boom alignment.
Fig 10
Aligning intermediate and outer sections
18-20 boom
1 Unfold the boom into the operating (spraying) posi-
tion.
2 Hold the M12x100 adjusting bolt, loosen the lock nut
(A Fig 11), and turn the nut (B Fig 11) so the cap of
the bolt head (C Fig 11) contacts the top stop plate
with the outer and intermediate sections aligned.
3 Check to ensure that the lock nut is tight.
Fig 11
24-28 boom
1 Unfold the boom into the operating (spraying) posi-
tion.
2 Hold the M12x70 adjusting bolt, loosen the lock nut
(A Fig 12), and turn the nut (B Fig 12) so the cap of
the bolt head (C Fig 12) contacts the stop plate with
the outer and intermediate sections aligned.
3 Check to ensure that the lock nut is tight.
Fig 12
Adjusting front fold cable
WARNING! Rear cable can snap and injure you or
someone else if tensioned when the boom is
unfolded. Always adjust the front cable first with
the boom unfolded and the rear cable last with the
boom folded in the transport position.
1 Unfold the boom into the operating (spraying) posi-
tion.
2 Shut the tractor off.
3 Slide a straight edge down the underside of the
intermediate section until it just contacts the front
cable.
C B
A
A
B
C
B
A