Hard Head 021095, Руководство по эксплуатации

Страница: 24 / 47

EN
24
immersed in fluid). The hose must also be
protected from freezing.
• A pressure relief valve must fitted if the
pressure in the water pipe is higher than
the specified value for the product,
otherwise the product will not work
properly. The manufacturer cannot
accept liability for any damages
resulting from improper use.
Emptying the product
NOTE:
• The power supply to the product must be
disconnected before the product is
emptied of water.
• Take suitable precautions to avoid water
damage when emptying the product.
1. Turn off the water supply.
2. Open the hot water tap can on the mixer.
3. The emptying tap (7) must be opened for
the water in the tank to run out. If there is no
such tap on the pipe the water can be taken
out directly from the inlet pipe on the tank
after it is disconnected from the water pipe.
FIG. 3
MAINS CONNECTION
• Only connect the product to a correctly
earthed power point.
• A hissing noise may be heard when the water
is heating. This is normal. The noise can
increase in time as a result of scale. Remove
scale regularly to avoid high level of noise.
TR = Thermostat
TS = Overheating protection
IL = Status light
R = Heater element.
FIG. 2
WARNING!
A damaged cord or plug must be replaced
by an authorised service centre or qualified
person to ensure safe use.
USE
Check that the product is full of water before
switching on the power. The product starts
when the plug is plugged into the mains.
1. Status light
2. Control dial for temperature
The status light (1) goes on when the product
is in heating mode. The status light (1) goes off
when the water reaches the set temperature
to indicate that the product is not heating.
The required temperature can be set with the
control dial (2) on the control panel.
FIG. 4
OVERHEATING PROTECTION
The product has over heating protection that
switches off the power to the product if the
temperature of the water is too hot.
WARNING!
If the overheating protection trips it will not
reset automatically and the product will not
work. Contact an authorised service centre.
MAINTENANCE
The manufacturer cannot accept liability for
any damage resulting from failure to follow
these instructions.
CLEANING THE OUTSIDE
Clean the product when necessary with a damp
cloth. Do not use abrasive detergent or solvent
on the product. Do not spray water or any
other liquid on the product.
SAFETY VALVE
The shut-off valve with safety valve must be
cleaned and checked at regular intervals to