Warning & Safety Instructions
SOLAR - MACH LIT &
ELECTRONIC IGNITION FIREPITS
OPERATIONS - ELECTRONIC IGNITION
Purge air in gas lines after system installation, this may
take several attempts. If after 15 attempts to light the
pilot it still won’t work, it will lock out. Please power off
then on to restart.
1. The firepit should be installed and inspected by a
certified plumber/ gas engineer before use.
2. Remove any debris found in the firepit before lighting.
Lava rocks/fire glass should not cover vents.
3. If lava rocks/fire glass is wet, allow time to fully dry
before using.
4. Turn on electrical power and gas to firepit.
5. Using wall switch or remote, turn on firepit - this may
take several cycles to purge any air.
6. The hot wire igniter will be powered (glow red) for 5
seconds before pilot valve opens.
7. The hot wire igniter will only be powered the initial
15 seconds of the 60 second pilot cycle. This sequence
will repeat up to 15 times (~15 minutes) before going into
lockout. To reset, turn off then back on again.
8. Pilot flame will ignite and warm thermocouple - it
may take 30 seconds at times for thermocouple to get
hot. If thermocouple is not hot in 60 seconds, system will
shut down then go back to Step 6.
9. Once thermocouple is hot, main valve will open
allowing main burner to ignite.
10. If pilot flame is out at any time, system will shut down,
then automatically restart.
11. Turn off firepit using remote control or wall switch.
12. Turn off power to electrical outlet and gas line when
not in use to prevent accidental start. Power to firepit
must be turned off via wall switch or breaker when not in
operation.
13. Allow firepit to cool before touching, covering or
maintaining/cleaning.
14. Cover the firepit using the provided all weather cover.
Overheating: The firepit will automatically close the gas
valve if temperature exceeds 175° F inside valve box to
prevent component damage. When unit cools below
175° F, the unit will automatically restart. To correct
overheating, ensure enclosure has adequate ventilation.
27 Edentrumley Road, Mayobridge, Newry, Co. Down, BT34 2SG
t.
UK
+44 (0)28 3085 0194
t.
ROI
00353 (0) 1524 0389
e.
w.
www.hardby.design
f.
www.facebook.com/hardbydesign
