SKU 95122
For technical questions please call 1-800-444-3353
Page 4
unpacking
When unpacking, check to make sure the following parts are included.
(6) Bolt, Washer
and Nut Sets
(3) Jaws
(6) Connector
Plates
(3) Bearing
Centers
Piston Shaft
Puller Unit
Handle
Puller Sleeve
Carrying Case
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
assembly
1. Thread the Puller Sleeve onto the Puller Unit about half way up.
2. Determine if the best grip on the part to be pulled is from the outside or
inside. If the part is to be gripped from the outside, the jaws will be installed
with their hooks facing inward. If the
part to be pulled will be gripped from
the inside, the hooks on the jaws will
be facing outward.
3. Determine if the upper or lower holes
in the jaws are to be used. The upper
hole is for larger items, approx. 6” -
10” in diameter, the lower holes are
for items smaller than 6”.
4. Assemble each of the three jaws
onto the Puller Sleeve using two
Connector Plates and two Bolt sets
as shown in the photo at right.
Connector Plates
Reversible Jaws
Puller Sleeve
Connector Plates
Reversible Jaws
Puller Sleeve
reV 01/07
Brought to You by www.snapwhole.com