Page 4
For technical questions, please call 1-888-866-5797.
Item 56683
Menu Navigation and Settings
1. Press the Menu Button to display the Menu on
the LCD Screen.
2. Use the Increase and Decrease Buttons (+/-)
to move up or down between options. Press
the Menu Button to select an option.
Peak and Track Mode
1. To change between Peak and Track Mode,
open the Menu, select the Mode Submenu,
and select the desired mode.
2. Peak Mode: Records the highest actual value
applied. After force is applied, LCD display will
flash for ten seconds before saving the peak
value to its memory. Memory can be reviewed
or cleared by accessing the Menu.
3. Track Mode: Displays the actual value, but
does not save the value to memory.
Adjusting Calibration Interval
1. The Calibration Reminder can be adjusted
from the Menu. Select “Cal Required” to select
Date, Cycles, or Off.
a. Date: Select between 6 or 12 months.
Confirm selection to save choice.
b. Cycles: Settings can be adjusted to a certain
cycle count, but it must be more than current
cycle count. Use the Increase and Decrease
Buttons (+/-) to adjust cycle count.
Note:
Current cycle count can be viewed by
selecting “Cycle Count” from the Main Menu.
2. The next time the “Cal Required” Submenu is
viewed, the selected setting will be displayed.
Additional Settings
1. Head Length can also be adjusted from the
Menu. Use the Unit Button to switch between
mm and in for Head Length.
Note:
When Head Length is not zero, “HEAD L
ADJ” will be displayed in place of the time on the
LCD Display.
2. Backlight settings can be changed from the
Menu. Backlight is always on by default but
can be changed to Auto or Off. In Auto, the
Backlight will turn on when any button in
pressed and remain on for twenty seconds.
3. Date and time can be adjusted from the Menu.
Date is in Year/Month/Day format and time is
in 24-hour HR:MIN:SEC format.
4. LCD Contrast can be adjusted from the Menu.
Use the Increase and Decrease Buttons (+/-)
to adjust the contrast (0 - 40).
5. Torque Wrench Key Beep can be turned on
or off from the Menu. Use the Increase and
Decrease Buttons (+/-) to navigate to your option
and then use the Menu Button to select it.
6. The Vibration function can be turned on or off
from the Main Menu.
7. Sleep Time can be adjusted from the Menu.
Wrench is preset to sleep after two minutes;
this time can be increased up to 8 hours.
8. The Language and Decimal Mark can be
changed from the menu. After Selecting the
Language Submenu, select between English
and Spanish. After a language is selected, select
between comma or point for the decimal mark.
9. Additional Information can be viewed from
the Menu. The Leave Factory Date (LFD), the
Calibration Date (CAL), and the In Service
Date (ISD) will be displayed in Year/Month/
Day format.
