Page 3
For technical questions, please call 1-888-866-5797.
Item 63313
Specifications
Electrical Rating
120VAC / 60Hz / 0.2A
Power Cord Length
12’
Maximum Flow @ 0’
264 GPH
Maximum Head lift @ 0 Flow
5.5′
Discharge Port
1/2″
Installation
The submersible motor pump must be installed in a stationary position with either:
a. A fixed pipeline or
b. A flexible hose pipe.
Please note!
1. Do not install the pump by suspending it
unsupported from its delivery pipe or power cord.
The pump must be suspended from the handle
or be placed on the bottom of the basin.
To ensure that the pump works properly,
keep the bottom of the fountain/water feature
free from sludge and dirt of all kinds.
2. If the water level sinks too low, any sludge in the
basin will dry out and stop the pump from starting.
Pump will not function unless fully submerged.
Power Supply
1. The pump is equipped with a shock-proof plug
according to regulations. The pump is designed to be
connected to 120 VAC, 60 Hz GFCI protected socket.
2. Make sure that the socket is sufficiently
secured and is in excellent condition.
3.
WARNING: To prevent death from electric
shock, pump must be connected only to
a GFCI protected outlet.
WARNING!
If the power cord or plug is damaged,
do not use the pump. The power cord or plug
may only be repaired by a certified electrician.
Areas of use
1. This pump is designed to pump water only.
2. This pump is designed to be used for:
Fresh-water aquariums and water features
3. This pump should NOT be used for:
Salt-water or brackish water
aquariums or water features.
Installation Instructions
1. Place the pump on the bottom of the aquarium/
water feature. Suction cups must be in contact with
the aquarium/fountain floor or a smooth platform.
2. Shift regulator to adjust flow rate.
