Page 8
SKU 97728
For technical questions, please call 1-800-444-3353.
Place the Housing Cap (30) over
•
the Housing (1) and turn clockwise
to tighten securely. At least two full
threads of the Router Base should
engage the threads of the Housing
Cap (30).
CAUTION: For added safety,
•
remove the bit after each use.
Air Supply
TO pREVEnT
ExplOSIOn:
Use only clean, dry, regulated,
compressed air to power this
tool. do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Tool
Air
compressor
Quick
coupler
Air Hose
on Reel
Filter
Regulator with
pressure gauge
Male
connector
Male
connector
Valve
Quick
coupler
Recommended Air line components
Oiler
1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown
in the diagram above.
An in-line
shutoff valve is an important safety
device because it controls the air
supply if the air hose is ruptured.
note:
If an automatic oiler system is
not
used, add a few drops of Pneumatic
Tool Oil
dAIlY
into the tool’s male
Quick Coupler before operation.
(See Figure A.)
Attach an air hose to the
2.
compressor’s air outlet. Connect
the air hose to the air inlet of the
tool. Other components, such as
a connector and quick coupler, will
make operation more efficient, but
are not mandatory.
WARnIng! TO pREVEnT SERIOUS
InjURY FROM AccIdEnTAl
OpERATIOn:
do not install a female quick
coupler on the tool.
Such a coupler
contains an air valve that will allow
the air tool to retain pressure and
operate accidentally after the air
supply is disconnected.
note:
Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
The air hose must be long enough
3.
to reach the work area with enough
extra length to allow free movement
while working.
Make sure the tool’s Trigger (3) is in
4.
the off position; refer to Operation
section for description of controls.
Close the in-line safety valve between
5.
the compressor and the tool.
Turn on the air compressor according
6.
to the manufacturer’s directions and
allow it to build up pressure until it
cycles off.
Adjust the air compressor’s output
7.
regulator so that the air output is
enough to properly power the tool,
