Page 10
For technical questions, please call 1-888-866-5797.
Item 58608
SAFE
TY
OP
ERA
TI
O
N
M
A
INT
EN
A
NC
E
SE
TU
P
General Instructions for Use
TO PREVENT SERIOUS INJURY FROM INJECTION: Wear ANSI-approved
eye protection and heavy-duty work gloves during use.
1. Make sure that the Trigger is in the
off-position, then attach the Battery Pack.
2. Prime Gun by simultaneously squeezing
the Trigger and opening the Air
Bleed Valve to expel any air pockets.
3. If grease will not flow, then air pockets likely remain:
a. Pull back on the Follower Rod Handle until
the Follower Rod is fully extended.
b. Open Air Bleed Valve and pull Trigger
repeatedly to pump grease through the Valve.
c. Push Follower Rod back into Grease Tube.
4. Clean the grease zerk fitting of the object to
be lubricated carefully and completely with
a clean cloth prior to attaching the Grease
Gun’s Coupler onto the zerk fitting.
5. Attach the Coupler by pressing it straight onto
the clean grease zerk fitting. Make sure that
the Coupler is fully seated on the zerk fitting
.
WARNING!
TO REDUCE THE RISK OF SERIOUS
INJURY FROM INJECTION:
It may be necessary to hold the Coupler in place
on the zerk fitting while lubricating.
While wearing
heavy-duty work gloves, hold the end of the
hose by the spring guard only. Keep hands
away from exposed rubber part of hose.
6. Squeeze the Trigger several times or
until a small amount of grease begins
to flow out of the greased bushing.
7. When greasing is complete, lock Trigger Lock,
then tilt Coupler, twist nozzle of grease gun,
and pull back to remove from zerk fitting.
(See below.) Wipe any excess grease from
exterior of the grease fitting and Coupler.
To Remove:
Tilt, Twist & Pull
8. To prevent accidents, turn off the tool and
remove its Battery Pack after use. Clean, then
store the tool indoors out of children’s reach.
