Page 5
For technical questions, please call 1-800-444-3353.
Item 99598
REV 12c
Cleaning
Read the ENTIRE IMPORTANT SAFEGUARDS section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC SHOCK:
Turn the appliance off, unplug the cord, and allow the appliance to cool completely before
performing any procedure in this section.
Do not immerse the motor/heating element, cord, or plug.
1. To prevent foodborne illness, wash the non-electrical
parts of the unit before assembly in warm,
soapy water, taking care to rinse completely.
2. Dry with a soft cloth. Wipe the motor/heating
element housing with a soft clean cloth or sponge.
3. Allow unit to dry completely before assembly or use.
4. After washing and drying, apply a small
amount of salad oil (not included) to
Cutting Plates to keep them lubricated.
CAUTION:
Do not clean with bleach, thinners or benzine.
These will damage or discolor Meat Grinder.
Assembly
Read the ENTIRE IMPORTANT SAFEGUARDS section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC SHOCK:
Turn the appliance off, unplug the cord, and allow the appliance to cool completely before
performing any procedure in this section.
Do not immerse the motor/heating element, cord, or plug.
Note:
For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
1. Slide Head (12) into Housing Opening (15).
While holding Head, place Locking Knob (22)
into slot on Left Motor Housing (21).
2. Turn Locking Knob clockwise until tight and
Head is fastened securely to housing.
3. Twist Feed Screw (100) long-end first
into Head. Continue twisting until Feed
Screw fastened into housing.
4. Slide Cutting Blade (9) onto Feed Screw, making
sure the edges of Cutting Blade face front of housing.
CAUTION!
Cutting Blade is sharp.
Wear gloves and use care when installing Cutting Blade.
5. Slide selected Cutting Plate (6, 7, or 8) over Cutting
Blade, using the slot along Plate edge as guide.
6. Screw Cap (1) into place on housing until secure.
WARNING! To prevent metal filings in food and
serious injury from grinder damage:
Lubricate with salad oil before use.
Do not overtighten Cap (1). Stop and check Cap (1)
periodically during use to ensure it remains tight.
7. Slide Hopper Plate (13) onto top of Head until secure.
8. Set Grinder on flat and stable counter space that
does not block vents along bottom of housing.
9. Cut foods into small pieces that
can easily fit into Hopper.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
