SKU 98250
For technical questions, please call 1-800-444-3353.
Page 9
Then turn Wheel Plate (9) clockwise
2.
to secure it on the Shaft (7).
oPerating inStructionS
read the entire imPortant
SaFety inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
The Pottery Wheel is equipped with
1.
a GFCI outlet. Always test the GFCI
prior to using the Pottery Wheel. If
the test of the GFCI fails, DO NOT
USE the Pottery Wheel. Have the
Pottery Wheel serviced immediately
by a qualified service technician.
Plug in the Pottery Wheel. The light
2.
on the GFCI (located near the plug)
should turn ON.
Press the TEST button. The light
3.
should turn OFF.
Reset the button. Light should turn
4.
ON again.
Work Piece and Work area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or expos-
ing the power cord to possible dam-
age.
There must not be hazardous ob-
3.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
Note the “Max. Fill” line on inside of
4.
the Tub (2). Do not fill with water
above this “Max. Fill” line.
general operating instructions
Direction
Switch (30)
Main
Switch (29)
Figure 4
1. Set Direction Switch (30) to FOR-
WARD or REVERSE-see Figure 4.
Press ON (1) Main Switch (29).
2.
Press (O) to set Main Switch (29) to
OFF.
Set the work piece on top of the
3.
Wheel Plate (9).
do not exceed
maximum weight capacity of 100
lbs.
Engage Foot Switch (32) to begin
4.
spinning Wheel Plate (9).
When finished working on the Pot
-
5.
tery Wheel, disengage pressure from
Foot Switch (32).
Turn OFF Main Switch (29).
6.
To prevent accidents, turn off the
7.
tool and disconnect its power supply
after use. Clean, then store the tool
indoors out of children’s reach.
REV 08g
