SKU 91006
Page 6
Maintenance
1.
To install the batteries: Open the safe door. The
battery compartment is located on the inside of the
safe door. Slide the batter y cover off the
compartment. Remove the old batteries, and install
4 new ‘C’ batteries in their place. Be sure to align
the polarity of the batteries as indicated in the battery
compartment. Replace the battery compartment
cover. Reset the code - see instructions on page 5.
2.
Low battery power warning: The red LED light on
the keypad will light when the batteries wear down.
When you observe the red LED light on, immediately
replace the batteries. To do this, follow the
instructions above.
3.
Protect the safe from moist or wet conditions.
This may cause electronic fault in the keypad, or
corrosion of the steel construction.
4.
Occasionally wipe the safe and keypad with a soft dry cloth or brush to
remove dust.
5.
Occasionally apply a small
amount of light oil or lock
lubricant to the mechanical lock
mechanism. Be careful not to get
any oil or other liquids on or near
the electronic mechanism.
6.
Occasionally apply a small
amount of oil to the wheel axles.
7.
Occasionally vacuum or brush
dust from the carpet lining of the
safe.
Battery Compartment
REV 05/04
