Unpacking
When unpacking, check to make sure the parts shown on page 5 are
included. If any parts are missing or broken, please call Harbor Freight Tools at the
number on the cover of this manual.
Operation
This 35MM Camera with Auto Drive and Flash is great for taking pictures
indoors and outdoors. It has a Flash Ready Indicator Light, Auto Rewind, a big View
Finder and a built-in Tripod Connection Hole (tripod not included).
Loading the Camera
Note:
Always load and unload the 33MM film in a low light or shaded area.
Bright light can damage the film. Only Alkaline batteries should be used.
1.
Load two “AA” Alkaline Batteries (not included). Looking at the bottom of the
Camera, press the black Latch (1) (under the Lanyard (3)) which opens the
door that houses the Batteries. Load according to positions indicated on the
inside of the Camera Battery Compartment.
(See Figure 1).
2.
Hold the Camera, back side facing you. Open the Back Cover (6) of the Camera
by pressing the Latch (5) on the left side of the Camera.
(See Figure 2)
.
3.
Put the roll of film (not included) in the Loading Slot (7) on the left side of the
Camera. Stretch the film over to the Take-up Spool (8), making sure that the
film fits across the bottom/middle of the Camera. Tuck film around Take-up
Spool (8) so it is down in the Recessed Area. Close the Back Cover (6) and
press the Trigger Button (9) until the “1” appears in the Indicator Window (4). If
this does not happen, open the Back Cover (6) again, advance the film an inch
or so more into the Recessed Area, close the Cover (6), and press the Trigger
Button (9) again. This should correct the problem. (See
Figure 2 & 3)
.
SKU 90959
Page 3
Battery Cover (2)
Lanyard (3)
Latch (1)
Figure 1
(Bottom of Camera)
Figure 2
Latch (5)
Loading Slot (7)
Take-up Spool (8)
Back Cover (6)
Figure 3
Film
Number
Indicator
Window
(4)
Recessed Area
Tripod Connector
Trigger Button (9)
