16
OPERATING INSTRUCTIONS
CAUTION:
The remote control transmitter can be programmed to multiple receivers or fans.
If this is not desired, turn wall switch off to any other programmable receiver or fan.
Locate remote control transmitter in remote pack (R).
Remove screw on the back of remote control
transmitter to remove battery cover. Install two AAA
batteries (included).
Replace battery cover on remote control transmitter
with screw just removed.
WARNING
: Batteries are to be inserted with the
correct polarity.
WARNING
:
Choking Hazard
- Small parts.
Keep battery away from children.
NOTE
: DO NOT mix old and new batteries; DO NOT
mix alkaline, standard (carbon - zinc), or rechargeable
(nickel - cadmium) batteries or equivalent.
NOTE:
Batteries are NOT rechargeable. Remove
battery with low or no charge and dispose of properly.
1.
(back
side)
1
Battery
Cover
CAUTION:
“DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR
LEAK.” - When disposing of household alkaline batteries, it is best to check with your local and state
recycling or household hazardous waste coordinators concerning the specifics of the program in your
area. You may also locate a recycling center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/recycle or www.earth911.org for more information.
Remote
Control
Transmitter
Battery
AAA
AAA
CAUTION: Changes or modifications not approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radio/TV technician for help.
Distributed by: Litex Industries Inc., P.O. Box 535639, Grand Prairie, TX, 75053; 1-800-527-1292
FCC Compliance Notice for Remote Control and LED Light Kit
