7
2.
Tape wire connectors (Q) and wires together with electrical
tape. [Fig. 2]
Warning:
Make sure no bare wire or wire strands are
visible after making connections. Place green and white
connections on opposite side of box from the black, orange and
blue (if applicable) connections.
1.
Make the necessary wiring connections for remote operation
according to Fig. 1. For each wire connection, use one of the
wire connectors (Q) provided, making sure to screw wire
connector (Q) on in a clockwise direction. [Make sure to
connect all
GROUND
(
GREEN
) wires together from fan (on
downrod and mounting bracket) to
BARE
/
GREEN
wire from
ceiling.]
WIRING TIP:
Wiring your fan's remote control requires extreme
patience. Take mandatory breaks while wiring to allow your
arms to rest.
Antenna
V
A
C
Fig. 3
Fig. 1
3.
Gently slide remote control receiver (V), flat side up, into
mounting bracket (C). Turn spliced/taped wires upward and
gently push wires and wire connectors (Q) into outlet box. Let
antenna from receiver (V) hang to the side. [Fig. 3]
Note:
The remote control included with this fan meets the
following requirements:
a.
Not for use with solid state fans.
b.
Electrical rating: 120V / 60 Hz; motor amps:1.0 MAX.;
light watts: 300 (incandescent only).
Fig. 2
Q
Q
Q
black
black
black
from fan
white
white
blue
blue
black supply wire
ground (green
or bare)
white supply wire
white
AC IN N
AC IN L
V
black
white
ground
(green or bare)
antenna
from receiver
from receiver
from ceiling
orange
orange
WIRING FOR REMOTE CONTROL
AND FAN
(continued from previous page)
FINAL INSTALLATION
(continued on next page)
Fig. 1
A
X
B
S
1
. Locate two canopy mounting screws (S) on underside of
mounting bracket (C) and remove screw (S) closest to the open
end of of the hanging bracket (C). Partially loosen the other
screw (S). Lift canopy (B) to mounting bracket (C). Place
rounded part of slotted hole in canopy (B) over loosened screw
(S) in hanging bracket (C) and push up. Twist canopy (B) to
lock. Re-insert screw (S) that was removed, and then tighten
both screws (S) securely. Slide canopy cover (X) up to canopy
(B), aligning rounded part of slotted holes in canopy cover (X)
with screwheads in bottom of canopy (B). Turn canopy cover
(X) to the right (clockwise) until it stops. [Fig. 1]
