14
WARNING:
Before beginning work, unplug fan to avoid electrical shock.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Fan does not move.
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Plugs in switch housing not connected
properly.
1. Push switch firmly either left or
right.
2. Turn power on or check fuse.
Make sure fan is plugged in
correctly.
3. Check that male and female plugs
in switch housing are connected
properly according to instructions
on page 10.
Noisy operation.
1. Blades are loose.
2. Cracked blade.
3. Fan is new.
1. Tighten all blade screws.
2. Replace blade.
3. Allow fan a “break in” period of
a few days, especially when
running the fan at Medium and
High speeds.
Excessive wobbling.
1. Blades are loose.
2. Blade arms incorrectly attached.
3. Unbalanced blades.
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing yoke is
(are) not tightened properly.
1. Tighten all blade screws.
2. Re-install blade arms.
3. Switch one blade with a blade
from the opposite side.
4. Turn power off. Make sure eye
bolt is secured to structure.
5. Use a longer downrod or move
fan to another location.
6. Tighten yoke set screw(s)
securely.
Fan operates but
light fails.
1. Wall switch to fan is off.
2. Wires in LED light kit not wired
correctly.
1. Make sure that wall switch to fan
is on.
2. Check that molex connections in
LED light kit are connected
properly according to instructions
on page 10.
NOTE:
A small amount of "wobble" is normal and should not be considered a defect.
