FAN MOUNTING
2. Insert downrod (A) through canopy (B), canopy
cover (G) and yoke cover (D). [
NOTE:
Canopy
cover (G) must be turned with the smooth side
toward
the motor housing (E).] Thread wires
from motor housing (E) through downrod (A).
Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the ball on the
downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
NOTE:
If you do
not
cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead
.
4.
3. Slip downrod (A) into yoke, align holes and
re-install pin (O) and clip (P). Tighten set screws
and then tighten nuts on the set screws. Slide
yoke cover (D) down until it rests on top of motor
housing (E).
8
Lowes.com/harborbreeze
Ball
4
2
3
A
Set Screws
and Nuts
O
A
P
E
D
G
A
B
D
