5. Fasten the blade bracket (E) to the motor by inserting
the alignment post into the slot on the bottom of the
motor housing (G) and tightening the blade bracket
screws with washers.
Please note that the blade bracket screws with washers
are pre-installed into the blade bracket (E). Repeat the
step for the remaining blade brackets (E).
6. Remove the three screws from the switch housing
cover (I).
If you wish to use the fan WITHOUT the light kit,
continue to Step 7.
If you wish to use the fan WITH light kit, skip to Step 8.
7. Attach the switch housing cover (I) to the switch housing
(H). Align holes in switch housing cover (I) with holes on
outer edge of the switch housing (H). (Note: The wide
gap in the edge of the switch housing cover (I) should
align with reverse switch on the switch housing (H).)
Re-insert screws and secure all screws.
Add fan pull chain extension (BB).
If using fan WITHOUT the light kit, assembly is complete.
13
12
5
8
6
9
7
10
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
screw with
washer
alignment
post
slot
E
G
I
H
I
BB
Hardware Used
Fan Pull Chain Extension x1
BB
FINAL INSTALLATION
FINAL INSTALLATION
8. Remove the plug from the center hole in the switch
housing cover (I).
9. Remove the hex nut from the light kit (J).
10. Insert the black and white wires from the light kit (J)
through the center hole in the switch housing cover (I).
Hold wires taut while installing switch housing cover (I)
to prevent the wire from twisting. Tighten the light kit (J)
onto the switch housing cover (I). Install the hex nut
removed in Step 9.
Plug
I
J
hex nut
I
J
hex nut
