9
WIRING
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire.
WARNING:
Make sure no bare wire or wire
strands are visible after making connections. Place
BARE/GREEN and WHITE connections on
opposite side of box from the BLACK and BLUE (if
applicable) connections.
2.
2.
CC
2
CC
CC
Hardware Used
Wire Connector
x 6
CC
FINAL INSTALLATION
1. Remove motor housing (C) from J-hook. Lift
motor housing (C) to mounting plate (A). Align
slotted holes on top rim of motor housing (C) with
loosened mounting plate screws (K) in mounting
plate (A). Twist motor housing (C) to lock.
Re-insert the two mounting plate screws (K)
previously removed (Step 3, page 6) and then
tighten all four mounting plate screws (K) to
secure motor housing (C).
1
A
K
K
C
3
Place remote control receiver (L) inside top of motor
housing (C). Turn spliced/taped wires upward and
carefully arrange wires and wire connectors (CC)
within top of motor housing (C).
NOTE:
The remote control included with this fan
meets the following requirements:
a.
Not for use with solid state fans.
b.
Electrical rating: 120V / 60 Hz;
motor amps:1.5 MAX.;
light watts: 16
LED 300VA
Should you choose to use a different remote control
with this fan, it must also meet these same
requirements.
3.
L
Antenna
C
CC
J-hook
Slotted
Hole
