6
7
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1
4
5
6
Lowes.com/harborbreeze
Lowes.com/harborbreeze
1. Securely attach the mounting plate (A) to the outlet box
(not included) using two screws (supplied with outlet
box). Pull the black, white and grounded wires out of the
outlet box through the hole in the mounting plate (A) and
lay them to the side.
Note:
Make sure the outlet box is securely installed in
place such that it is able to support at least the fan
weight.
2. Carefully lift the motor (B) and engage the slot in the
preassembled bracket with the hook on the mounting
plate (A) so it is securely suspended.
3. Connect the supply
GROUNDED/GREEN
wire to
the
GREEN/GROUNDED
wires from the motor
bracket using the wire connector (AA). Connect the
fan motor
WHITE
wire to the supply
WHITE
wire
using the wire connector (AA). Connect the fan
motor
BLACK
and
BLUE
wires to the supply
BLACK
wire using the wire connector (AA).
NOTE:
Black wire is hot power for fan. Blue wire is
hot power for light kit. White wire is common for fan
and light kit. Green wire is grounded wire. lf house
wires are different colors than referred to above,
stop immediately. A professional electrician is
recommended to determine proper wiring.
4. Tape the wire connectors (AA) and wires together. The
wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on
one side of the outlet box and the ungrounded conductor
on the other side of the outlet box. Be sure no bare wire
or wire strands are visible after making connection. Place
green and white connections on opposite side of box
from the black and blue connections. The splices should
be turned upward and pushed carefully up into the outlet
box.
5. Lift the motor bracket so the threaded studs on the
mounting plate (A) protrude through the slots in the
motor bracket. Securely tighten the three lock nuts (BB)
onto the threaded studs.
Note:
Lightly shake the motor
bracket to ensure the assembly is tight.
6. Align the four clips on the inside of the motor housing (D)
with the four slots on the outer edge of the mounting
plate (A). Twist the motor housing (D) clockwise until it
stops to hold on the mounting plate (A).
A
A
B
E
B
Outlet box
Screw
2
Bracket
Threaded
stud
Motor bracket
BB
A
BB
Hardware Used
x 3
Clip
Slot
Hardware Used
x 4
AA
AA
A
D
Wire Connector
Lock Nut
3
Grounded/
Green
Black
White
Green
Black
Blue
White
outlet box
blue blac
k
white green
white
GREEN/
black
Supply circuit
speed
switch
GROUNDED
