15
FINAL INSTALLATION
7. Remove the preassembled finial (L), finial cap (K), hex
nut (T) and rubber washer (U) from the light kit (J). Lift
the glass bowl (N) onto the threaded rod at the bottom
of the light kit (J).
Feed the pull chain coming from the grommet in the
light kit (J) through the off-center hole in the glass bowl
(N). Feed the pull chain coming from the center of the
light kit (J) through the center hole in the glass bowl (N).
Secure glass bowl (N) with rubber washer (U) and hex
nut (T). Then attach finial cap (K) and finial (L).
Proceed to Step 10.
8.
To install the fan without the light kit (J),
remove
the preassembled hex nut and lock washer from the
threaded rod on the inside of the switch housing (I).
Remove light kit (J) from the switch housing (I) and
discard, then install the plug button (EE) into the center
hole of the switch housing (I).
Hardware Used
EE
Plug Button
x 1
9. Remove the three switch housing screws (X) from the
fitter plate (H). Then, a
ttach the switch housing (I) to the
fitter plate (H) using the switch housing screws (X).
8
I
EE
I
J
U
N
J
T
K
L
7
I
X
H
9
Hex Nut
Lock Washer
