12
Lowes.com/harborbreeze
WIRING
WARNING:
To reduce the risk of fire, electrical shock or personal injury, wire connectors provided
with this fan are designed to accept only one 12-gauge house wire and two lead wires from the fan. If
your house wire is larger than 12 gauges and/or there is more than one house wire to connect to the
fan lead wire (red), consult an electrician for the proper size wire connectors to use.
CAUTION:
Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present.
1. Make the following wire connections according to the
diagram and these steps:
• Push the White (common/neutral) supply wire into
the empty wire hole of the push-in wire connector
preassembled to the White wire from the receiver of
remote pack (P).
• Push the Black (Live/Hot) supply wire into
the empty wire hole in push-in wire connector
preassembled to the Red wire from the receiver of
remote pack (P).
Important:
The wire harness and the Bare/Green
(ground) supply wire will be connected later. If supply
wires are different colors than referred to above, a
professional electrician should determine proper wiring.
CAUTION:
Fan must be installed with included
receiver.
Black (Live/Hot)
Bare/Green (Ground)
White (Common/Neutral)
Wire Harness
Whit
e
Antenna
Red
Receiver
2. Connect the Green wires from the downrod (A) and
the mounting bracket (E) to the Bare/Green (ground)
supply wire using a wire connector (BB).
Note:
Closemount installation does not use a downrod (A),
so there will only be two Green wires to connect.
Then, wrap electrical tape (not included) around the
wire connector (BB) down to the wire.
Hardware Used
BB
Wire Connector
x 1
3. Turn the spliced/taped wires upward and gently push
the wires and connectors into the outlet box.
WARNING:
Ensure no bare wire strands are visible
after making connections. Place White wire connections
on opposite sides of outlet box from the Black.
1
E
2
A
BB
3
