10
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
4. Depending on the length of downrod you use, you may
need to cut the lead wires back to simplify the wiring. If
you decide to cut back the lead wires, it is suggested
you do so in the following manner: Take the lead wires
and make sure you have pulled them all the way
through the top of the downrod. Measure 8 inches of
lead wire, then cut the excess wire off with wire cutters
(not included).
CAUTION:
Do not cut the braided cable.
5. If you decided to cut back the lead wire in Step 10, strip
1/2 in. of insulation from the end of the wires. Twist
the stripped ends of each strand of wire within the
insulation with pliers (not included).
Note:
If you did not cut back the lead wires in Step 10,
Step 11 is not necessary and you may proceed to Step
12 instead.
6. Install the ball end of the downrod (A) into the opening
of the mounting bracket (D). Align the slot in the ball
with the tab in the mounting bracket (D).
Note:
The
downrod (A) should not rotate if installed correctly.
DANGER:
Failure to align the slot in the ball with
the tab could cause the fan to fall, which may result in
serious injury or death.
5
A
D
6
4
Braided Cable
Slot
Tab
8 in.
