12
13
FINAL INSTALLATION
5. Align the post of blade bracket (G) to the slot on the
bottom of the motor housing assembly (F). Secure each
blade bracket (G) using 2 blade bracket screws (EE).
Repeat this step for the remaining blade assemblies.
8. Remove and save three preassembled screws from
light kit (J). Connect the
BLUE
wire from motor
assembly (F) to
BLACK
wire from light kit (J).
Connect
WHITE
wire from motor assembly (F) to
WHITE
wire from light kit (J).
Attach the light kit (J) to the switch box (I) on bottom
of motor assembly (F). Replace the previously
removed screws and securely tighten all screws.
9. Remove the preassembled finial (M), glass cap (L),
rubber washer and hex nut from light kit (J).
10. Place glass (K) on the preassembled pipe on the
light kit (J) until it is flush with the preassembled
metal disk. Thread fan pull chain through side
hole on glass (K). Make sure pull chain hangs
clear and is not tangled in light kit (J). Thread light
kit pull chain through center hole on glass (K).
Place previously removed rubber washer and hex
nut onto the pipe and securely tighten.
FINAL INSTALLATION
7. Connect the MALE plug from motor assembly (F)
to the FEMALE plug from switch box (I). Attach the
switch box (I) to the bottom of the motor assembly
(F) by aligning the keyholes on the switch box (I) with
the loosened screws on the support plate of motor
assembly (F). Twist switch box (I) until the loosened
screws engage the narrow end of the keyholes, then
replace previously removed screw and securely
tighten all screws.
6. Loosen two of the three preassembled screws from
the support plate of motor assembly (F). Remove
and save remaining preassembled screw.
EE
Blade Bracket Screw
x 10
Hardware Used
H
B
FF
5
H
B
FF
6
7
8
9
10
EE
F
Screw
F
Black
Blue
White
J
I
Rubber washer
Hex nut
M
L
J
Rubber washer
Hex nut
K
Keyhole
Male plug
Female plug
Screw
I
F
Lowes.com/harborbreeze
Lowes.com/harborbreeze
